• Series 10 Standard Leak Test Machine
• Series 20 Standard Leak Testing Fixture
• Series 40 Standard Leak Testing Fixture
• Twin Station Series 40 Standard Leak Testing Fixture
• Series 40 Standard Leak Test Machine with Interchangeable Fixtures

• TQC Equipment
• 'Chilled Beam' Leak Test
• Fuel Rail Leak & Burst Testing
• Fuel Tank Leak Testing
• High Pressure Audit Leak Test and Datalogging System
• High Speed Leak Testing of Plastic Vials for the Medical Industry
• High Speed Leak Testing of Pipe Fittings
• Leak Testing of Engine Blocks
• Leak Test, Flexible Facility
• Leak Test Facility for Water Valves
• Medical Device Leak Testing
• Medical Filter Leak Test Machine
• Medical Shower Head Leak Test Facility
• Plastic Sump Pipe Leak Test & Inserter
• Small Medical Device Leak Test
• V6 Engine Leak Testing
• Vauxhall Leak Test Machine
• Water Submersal Leak Detection
• Weapon Leak Test

• Product Datasheets
• Video Clips

• TQC Home Page
• Leak Test Machines
• Assembly Automation
• Test Machines
• Plastics Machines
• Engineering Design Services

Twin Station Series 40

        Standard leak testing equipment

TQC have recently developed a low cost, standard leak testing machine with integral or bus system plc control. The machine incorporates a Nolek S9 leak test instrument which allows a dedicated leak test valve module per test fixture with a single panel mounted display unit.

To increase throughput, a twin station machine is available allowing a single operator to work alternately between the two fixtures, or two operators working independently on each fixture.

The unit incorporates:

	Standard aluminium extrusion bench
	Universal fixture areas
	Light guard access to each station
	Fully automatic sealing fixture
	PLC control system
	Built in Nolek S9 leak test instrument
	Standard operator interface panel
	Suitable for medium to high volume applications

The machine displayed above shows the testing of pressed steel oil sumps which were tested by a single operator at a rate in excess of 1 every 30 seconds. The fully automatic sealing fixtures include a pass marker unit. The leak test was performed at a differential pressure of 1 bar with maximum leak rate of 200mm3/sec.

This series is configurable for either over-pressure, vacuum or dosing applications.

For a printer friendly sheet on the Twin Station Series 40 leak test unit please visit our datasheets area or for futher leak testing machines and systems please visit our applications area. 

If you are currently considering a leak test application contact TQC to discuss your requirements.