• Series 10 Standard Leak Test Machine
• Series 20 Standard Leak Testing Fixture
• Series 40 Standard Leak Testing Fixture
• Twin Station Series 40 Standard Leak Testing Fixture
• Series 40 Standard Leak Test Machine with Interchangeable Fixtures

• TQC Equipment
• 'Chilled Beam' Leak Test
• Fuel Rail Leak & Burst Testing
• Fuel Tank Leak Testing
• High Pressure Audit Leak Test and Datalogging System
• High Speed Leak Testing of Plastic Vials for the Medical Industry
• High Speed Leak Testing of Pipe Fittings
• Leak Testing of Engine Blocks
• Leak Test, Flexible Facility
• Leak Test Facility for Water Valves
• Medical Device Leak Testing
• Medical Filter Leak Test Machine
• Medical Shower Head Leak Test Facility
• Plastic Sump Pipe Leak Test & Inserter
• Small Medical Device Leak Test
• V6 Engine Leak Testing
• Vauxhall Leak Test Machine
• Water Submersal Leak Detection
• Weapon Leak Test

• Product Datasheets
• Video Clips

• TQC Home Page
• Leak Test Machines
• Assembly Automation
• Test Machines
• Plastics Machines
• Engineering Design Services

Vauxhall V6

Inlet manifold leak test facility

The manifold leak test station consists of a test unit located in the V6 engine assembly area, and is a self contained, free standing unit consisting of an aluminium frame on which is mounted a loading fixture, an operator control closure, an electrical closure, a pneumatic air compressor and a hydraulic power pack.

The test component is manually loaded to a retractable drawer, at which time an operator is required to connect the wiring harness to the connector provided and also connect the fuel rail connectors. At this point the drawer is closed and the sealing begins.

The instrument controls the complete leak test cycle, including fill, stabilisation and measurement, basic operating principle is that of measuring pressure decay in the test volume as compared with the pressure in a reference volume, both having stabilised to the same pressure before starting the measurement.

The facility is designed to carry out four automatic air decay tests on a manually loaded assembly. These tests are on the:

Air inlet branches

Fuel rail assembly

The opening value of the regulator       fitted                            

Resistance test checking each type of injector

Test pressures are controlled by an E-P regulator and are set to nominally 1.5 bar for the manifold, 4.0 bar for the fuel rail and 3.4 bar for the regulator.

Test parameters (time, alarm limits, etc) are programmable via the key pad on each instrument.

Results are indicated in terms of leakage rates (converted to cu.mm/sec) on each instrument when a positive leakage is measured.